Logo letter

Ways of Jump Starting a Car

 

 

Because you do not know when your car battery will fail to work, you should be well equipped with knowledge on how to jump start your car safely.  There are professional who are well experienced on the issues concerning car jump start who you should contact when you are not getting everything right because however much it can be easy, if you make an error it can be hazardous.  Jumper cables are the main equipment that you should have when you are ready to jump start your car. The following procedures are to help you in jump starting your car safely.

 

You should be able to check the location of your battery, or you can check the manual of the car if you are not sure where it is.  The position of the car providing the jump and your car should be in a correct position.  The positioning of the car providing the jump next to your car will help in ensuring that the jumper cables reach your car battery without any problem.  Ensure that the jumper cables reach both the car's battery by placing the cars so closely.  Switch off the car providing at http://jandltowing.net/jump-starts.php the jump and note that the hoods of the both cars should remain opened.

 

Identify the car that is providing the jump and clamp one end of the jumper cables onto the battery. Remember that the cables are of different color that is, red to stand for positive and black to stand for negative. The red clamp should be connected to the red terminal of the battery  and then the black clamp to the negative terminal of the battery.  The connection of the clamps according to the colors should be made in both the car that is providing the jump and your car and also avoid so much the contact between the two different clamps to avoid dangerous electrical spark.

 

By connecting the black clamp to the engine, the spark produced around the battery will automatically be reduced. After all these procedures, you can now start the engine of the car giving you the jump and leave it to run for about ten minutes to help in the charging the dead battery.  You should observe keenly whether your car will start by turning the key in your ignition.

 

After starting your car and ensuring that it can start, then remove the clamps as follows, the black clamp should be remove first and the red clamp after that. The last one, you should give your car to a mechanic at http://www.jandltowing.net/flatbed-service.php after jump starting it to ensure that there is no additional problem engage in your car.